Specifications: Voltage: 12V Power: 45W Inlet pipe size: 8 x5mm, 6 x4mm(Outside diameter x inside diameter) Outlet pipe: 11cm / 4.33in Flow: 4L/MIN Weight: 850g Note for use of pump: 1. Start the car, run the engine for a while, the oil temperature is about 50 degrees, and then start pumping 2. Power on, run the pump for a while, and observe whether the inlet port of the pump is normal. Open the fuel cap, extract Oil scale, the pipe inserted to the bottom of the connector, and then insert the oil inlet from the oil scale position to the end, If the oil is not pumped out or comes up very slowly and intermittently, it is usually caused by loose tube and joint, taken out and tightened again 4. After pumping the oil, take out the pipe and run the pump for a while, or pump out the remaining oil in the pump, or clean the pump for a while until the pump head is clean 5. If the interval is not used for a long time, the pump may not have suction .Fill the pump with water, idling for a few minutes, and drain the air, then it can be used normally Package includes: 1 x Oil Pump with clips 2 x inlet pipe 1 x outlet pipe